
BTM Botanik
BTM Botanik is a polyester felt-reinforced waterproofing membrane made of bitumen modified by SBS (styrene-butadiene-styrene), resistant to plant roots, coated with PE (polyethylene) film on the upper and lower surfaces, having a high elasticity, applied with an oxyacetylene burner or hot asphalt. BTM produces four different membranes under the designation of Botany.
PLACES OF USE
Used to obtain waterproofing on:
- garden terrace roofs of buildings,
- such parts as curtain walls and foundations which contact the soil.
- It is not only designed for cold climates but may also be used as lower and middle layer membrane in waterproofing to be made on any surfaces which contact any types of soil and require elasticity.
SURFACE PREPARATION
Surface on which application shall be carried out must be cleaned of any dust, dirt, rust and grease and any loose parts scraped.
APPLICATION
If the surface to be insulated is concrete, then it must have been finished with sloping grout burnished using a wooden trowel and be clean and dry. Before the application of the membrane, the surface must have been spread with bituminous solution undercoat BITUSOL (TS 103) or bituminous emulsion undercoat BITUMER (TS 113) and allowed to dry up. Membranes start to be applied in a direction perpendicular to the slope at the lowest part of the roof (lowest elevation). The membrane is heated up with oxyacetylene burner flame and then adhered to the surface. The rows must must be laid with some shift sideways. Membranes must be overlapped 15cm on the short sides and 10cm on the long ones, and the seams must be well adhered. Between the layers, there must be a shift sideways for 50cm on the short side and 5m on the long one.
PACKAGING
Botanik is launched into the market in rolls 1m wide and 10m long.
STORAGE CONDITION AND SHELFLIFE
Rolls must be vertically stored in roofed-over spaces. If the rolls have to be stored outdoors for a long period of time, then they must be covered with a protective layer in order to protect them against the sunlight. If the rolls are to be stowed without pallets, they they are not stacked one on top of another. In palletised stowage, two rows may be stacked one on top of the other.
BTM Bitümlü Tecrit Maddeleri Sanayi ve Ticaret A.Ş. Kemalpaşa O.S.B. Mahallesi Gazi Bulvarı No:152 35730 Kemalpaşa/İzmir TURKEY Phone:+90 232 877 04 02 Fax:+90 232 877 04 10 info@btm.co • www.btm.co
Technical documents
Technıcal Data Sheets
- PDFBotanik PP 4000PDF ↓
- PDFBotanik PP 3000PDF ↓
- PDFBotanik PE 3Request document
Declaratıon of Performance
- PDFDOP4/2: 13707-13969 Botanik MembranesPDF ↓
Qualıty Certıfıcates
- PDFCE Certificate 13969PDF ↓
Products in the same group

Extensive Greening
It is used as a separator layer under the ground in green roof areas - on the drainage plate with water holding reservoir, to filter the water and to prevent the soil from filling into the drainage plate. More ...

BTM Green System Filter 110 gr/m2
It is used as a separator layer under the ground in green roof areas - on the drainage plate with water holding reservoir, to filter the water and to prevent the soil from filling into the drainage plate. More ...

BTM Optıgreen FKD25 Drainage Board
Rapid discharge of surplus water prevents the accumulation of water on non-pitched roofs and in large drainage lengths Light build-up with high drainage capacity More ...

BTM Green Protection and Storage Mat 500 gr/m2
Excess water accumulated in the drainage boards with water holding reservoir in the green roof areas overflows from the holes and accumulates on the geotextile felt in a lower layer, this type of covers is called a moist