
BTM Botanik
BTM Botanik is a polyester felt-reinforced waterproofing membrane made of bitumen modified by SBS (styrene-butadiene-styrene), resistant to plant roots, coated with PE (polyethylene) film on the upper and lower surfaces, having a high elasticity, applied with an oxyacetylene burner or hot asphalt. BTM produces four different membranes under the designation of Botany.
PLACES OF USE
Used to obtain waterproofing on:
- garden terrace roofs of buildings,
- such parts as curtain walls and foundations which contact the soil.
- It is not only designed for cold climates but may also be used as lower and middle layer membrane in waterproofing to be made on any surfaces which contact any types of soil and require elasticity.
SURFACE PREPARATION
Surface on which application shall be carried out must be cleaned of any dust, dirt, rust and grease and any loose parts scraped.
APPLICATION
If the surface to be insulated is concrete, then it must have been finished with sloping grout burnished using a wooden trowel and be clean and dry. Before the application of the membrane, the surface must have been spread with bituminous solution undercoat BITUSOL (TS 103) or bituminous emulsion undercoat BITUMER (TS 113) and allowed to dry up. Membranes start to be applied in a direction perpendicular to the slope at the lowest part of the roof (lowest elevation). The membrane is heated up with oxyacetylene burner flame and then adhered to the surface. The rows must must be laid with some shift sideways. Membranes must be overlapped 15cm on the short sides and 10cm on the long ones, and the seams must be well adhered. Between the layers, there must be a shift sideways for 50cm on the short side and 5m on the long one.
PACKAGING
Botanik PE4 is launched into the market in rolls 1m wide and 10m long.
STORAGE CONDITION AND SHELFLIFE
The membrane rolls should be stored vertically under a roof, protected from direct sunlight. If the rolls have to be stored outdoors for a long period of time, they must be covered with a protective layer in order to protect them from the sunlight.The membrane rolls or pallets should not be stacked on each other.
BTM Bitümlü Tecrit Maddeleri Sanayi ve Ticaret A.Ş. Kemalpaşa O.S.B. Mahallesi Gazi Bulvarı No:152 35730 Kemalpaşa/İzmir TURKEY Phone:+90 232 877 04 02 Fax:+90 232 877 04 10 info@btm.co • www.btm.co
Products in the same group

BTM Elastobit
BTM Elastobit is a fiberglass or polyester felt reinforced waterproofing membrane made of bitumen modified by SBS (styrene-butadiene-styrene), resistant to plant roots, the lower surface is coated with PE (polyethylene)

BTM Plastobit
Plastobit is a fiberglass or polyester felt reinforced waterproofing membrane made of bitumen modified with APP (atactic polypropylene), the lower surface is coated with PE (polyethylene) film and the upper surface is co

BTM Plastobit PP4000V
BTM makes available in its range of products the viaduct type sheeting with a thickness of 4 mm and high tensile strength manufactured specially for such insulation applications thanks to its expertise in waterproofing.

BTM Polibit
BTM Polibit is a fiberglass or polyester felt reinforced waterproofing membrane made of bitumen modified with APP (atactic polypropylene), the lower surface is coated with PE (polyethylene) film and the upper surface is