BTM Plastobit Waterproofing Membranes were preferred for the Regnum Göl Evleri Project in Antalya.
BTM Plastobit PP3000 product was applied on an area of 90.000 m2 in the project, the application of which was undertaken by BTM Dealer Sarılar Yapı. BTM Polpan XPS Extruded Polystyrene Thermal Insulation Boards were also used in the project.
BTM Plastobit:
Plastobit is a waterproofing membrane with fiberglass or polyester felt carrier, produced from bitumen modified with APP (atactic polypropylene), covered with PE (polyethylene) film on the lower and upper surfaces, and applied with a torch.
Usage places:
• On terrace roofs of buildings,
• On sloping concrete roofs,
• BTM Waterproofing Membrane Plastobit is used to obtain water and moisture impermeability on shear walls and foundations.
• Designed for temperate climates, BTM Waterproofing Membrane Plastobit is used as the lower and middle layer cover in waterproofing.
• BTM Waterproofing Membrane Plastobit It is used in wet areas such as bathrooms and kitchens and on foundations with pressurized or unpressurized underground or surface water.
For more information:
https://www.btm.co/en/btm-plastobit
BTM Polpan XPS:
Polpan is a closed cell extruded polystyrene rigid foam thermal insulation board. These plates, which are 2, 3, 4, 5, 6, 7, 8, 9 and 10 cm thick, are 60 X 120 cm. in size.
Usage places:
• Polpan thermal insulation board, on terrace roofs of buildings,
• On sloping concrete roofs,
• On mounted roofs,
• On floors,
• In suspended ceilings,
• In basic curtain walls,
• It is used for thermal insulation in foundations.
For more information:
https://www.btm.co/en/btm-polpan-n